Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
To disable inbound Telnet access:
ProCurve(config)# no telnet-server
To re-enable inbound Telnet access:
ProCurve(config)# telnet-server
Outbound Telnet to Another Device. This feature operates indepen-
dently of the telnet-server status and enables you to Telnet to another device
that has an IP address.
Syntax: telnet <ipv4-addr | ipv6-addr | hostname | switch-num>
Initiates an outbound telnet session to another network
device. The destination can be specified as:
• IPv4 address
• IPv6 address
• Hostname
• Stack number of a member switch (1-16) if the
switch is a commander in a stack and stacking is
enabled
For example, if the host “Labswitch” is in the domain abc.com, you can enter
the following command and the destination is resolved to
“Labswitch.abc.com”.
ProCurve(config)# telnet Labswitch
You can also enter the full domain name in the command:
ProCurve(config)# telnet Labswitch.abc.com
You can use the show telnet command to display the resolved IP address.
7-6
To Next Page
Loading...
