Troubleshooting
Diagnostic Tools
Basic Link Test
Link Test with
Repetitions
Link Test with
Repetitions and
Timeout
Link Test Over a
Specific VLAN
Link Test Over a
Specific VLAN;
Test Fail
Figure C-15. Example of Link Tests
Traceroute Command
The traceroute command enables you to trace the route from the switch to a
host address.
This command outputs information for each (router) hop between the switch
and the destination address. Note that every time you execute traceroute, it
uses the same default settings unless you specify otherwise for that instance
of the command.
Syntax: traceroute < ip-address | hostname >
traceroute6 < ip-address | hostname >
Lists the IP address or hostname of each hop in the route,
plus the time in microseconds for the traceroute packet reply
to the switch for each hop.
To halt an ongoing traceroute search, press the
[Ctrl][C] keys.
Note: For information about traceroute6, see the “IPv6
Configuration Guide” for your switch.
C-54
To Next Page
Loading...
Need help?
General