Troubleshooting
Viewing Switch Configuration and Operation
CLI: Useful Commands for Troubleshooting Sessions
Use the following commands in a troubleshooting session to more accurately
display the information you need to diagnose a problem. For more information
on other these CLI practices, refer to chapter Chapter 4, “Using the Command
Line Interface (CLI)”.
Syntax: alias
Creates a shortcut alias name for commonly used commands
and command options.
For more information, see ““Using a Command Alias” ” in the
“Using the Command Line Interface (CLI)” chapter.
kill
Terminates a currently running, remote troubleshooting
session. Use the show ip ssh command to list the current
management sessions.
For more information, see “Denying Interface Access by
Terminating Remote Management Sessions” in the “Interface
Access and System Information” chapter.
[no] page
Toggles the paging mode for show commands between
continuous listing and per-page listing.
repeat
Repeatedly executes one or more commands so that you can see
the results of multiple commands displayed over a period of
time. To halt the command execution, press any key on the
keyboard.
For more information, see “Repeating a Command” in the
“Using the Command Line Interface (CLI)” chapter.
setup
Displays the Switch Setup screen from the menu interface.
C-66
To Next Page
Loading...
Need help?
General
