EasyManuals Logo

HP PROCURVE 2520 User Manual

HP PROCURVE 2520
544 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #378 background imageLoading...
Page #378 background image
File Transfers
Downloading Switch Software
Note Downloading new switch software does not change the current switch con-
figuration. The switch configuration is contained in separate files that can also
be transferred. Refer to “Transferring Switch Configurations” on page A-22.
In most cases, if a power failure or other cause interrupts a flash image
download, the switch reboots with the image previously stored in primary
flash. In the unlikely event that the primary image is corrupted (which may
occur if a download is interrupted by a power failure), the switch goes into
boot ROM mode. In this case, use the boot ROM console to download a new
image to primary flash. Refer to “Restoring a Flash Image” on page C-68.
Using TFTP To Download Switch Software from a
Server
This procedure assumes that:
â–  A software version for the switch has been stored on a TFTP server
accessible to the switch. (The software file is typically available from the
ProCurve Networking web site at www.procurve.com.)
â–  The switch is properly connected to your network and has already been
configured with a compatible IP address and subnet mask.
â–  The TFTP server is accessible to the switch via IP.
Before you use the procedure, do the following:
â–  Obtain the IP address of the TFTP server in which the software file has
been stored.
â–  If VLANs are configured on the switch, determine the name of the VLAN
in which the TFTP server is operating.
â–  Determine the name of the software file stored in the TFTP server for the
switch (for example, E0820.swi).
Note If your TFTP server is a UNIX workstation, ensure that the case (upper or
lower) that you specify for the filename is the same case as the characters
in the software filenames on the server.
Menu: TFTP Download from a Server to Primary Flash
Note that the menu interface accesses only the primary flash.
1. In the console Main Menu, select Download OS to display the screen in
figure A-1. (The term “OS”, or “operating system” refers to the switch
software):
A-4

Table of Contents

Other manuals for HP PROCURVE 2520

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP PROCURVE 2520 and is the answer not in the manual?

HP PROCURVE 2520 Specifications

General IconGeneral
Web InterfaceYes
CLI SupportYes
IPv6 SupportYes
Auto-MDIXYes
SNMP SupportYes
Quality of Service (QoS)Yes
VLAN SupportYes
Jumbo Frame SupportYes

Related product manuals