Power-Saving Features
Configuring Power-Saving for LEDs
Configuring Power-Saving for LEDs
The savepower led command provides the ability to turn off the switch link,
mode, and activity LEDs and turn them on again. When power-saving is turned
off, it will turn on again automatically after 10 minutes.
Syntax: [no] savepower led
Turns power-saving option on or off for the LEDs
ProCurve(config)# savepower led
Figure F-1. Example of Setting savepower led Command
The no form of the savepower led command cancels power saving mode and
the LEDs are returned to their original state.
Show Savepower Status
To display the configured status of the LED power-saving option, use the show
savepower led command.
ProCurve(config)# show savepower led
Led Save Power Status: Enabled
Figure F-2. Example of Output for show savepower led Command
F-2
To Next Page
Loading...
