HP PROCURVE 2520 User Manual

Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
Table 10-2. Protocols and Modes Supported for Copper Ports
10/100 Mbps Gigabit
10/100 TX 10/100/1000-T
Modes Settings Modes Settings
Auto
10HDx
100HDx
10FDx
100FDx
Auto-10
100FDx
10HDx
100HDx
10FDx
100FDX
10FDX
Auto
Auto-10
Auto-100
Auto-10-100
Auto-1000
10HDx
100HDX
1000FDx
10HDx
100FDx
100FDx
1000FDx
10HDx
100HDx
Table 10-3. Protocols and Modes Supported for Fiber Optic Ports
100 Mbps Gigabit
Protocols 100BASE-FX
100BASE-BX10
1000BASE-SX
1000BASE-LX
1000BASE-BX10
1000BASE-LH
Modes 100HDx Auto
100FDx
1000FDx
Configuring Ports
You can configure and view the port settings by using the menu.
Note The menu interface uses the same screen for configuring both individual ports
and port trunk groups. For information on port trunk groups, refer to Chapter
12, “Port Trunking” .
1. From the Main Menu, Select:
2. Switch Configuration...
2. Port/Trunk Settings
An example of the Menu display is shown below.
10-7

HP PROCURVE 2520 Specifications

General

Web Interface	Yes
CLI Support	Yes
IPv6 Support	Yes
Auto-MDIX	Yes
SNMP Support	Yes
Quality of Service (QoS)	Yes
VLAN Support	Yes
Jumbo Frame Support	Yes