Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
Reconfigure the Console/Serial Link Settings. You can reconfigure one
or more console parameters with one console command.
Syntax: console
[terminal < vt100 | ansi | none >]
[screen-refresh < 1 | 3 | 5 | 10 | 20 | 30 | 45 | 60 >]
[baud-rate
< speed-sense | 1200 | 2400 | 4800 | 9600 | 19200 |38400 | 57600 |
1155200 >]
[ flow-control < xon/xoff | none >]
[inactivity-timer < 0 | 1 | 5 | 10 | 15 | 20 | 30 | 60 |120 >]
[events <none | all | non-info | critical | debug]
[local-terminal <vt 100 | none | ansi>]
Note If you change the Baud Rate or Flow Control settings for the switch, you
should make the corresponding changes in your console access device. Other-
wise, you may lose connectivity between the switch and your terminal
emulator due to differences between the terminal and switch settings for these
two parameters.
All console parameter changes except events and inactivity-timer require that
you save the configuration with write memory and then execute boot before the
new console configuration will take effect.
For example, to use one command to configure the switch with the following:
â– VT100 operation
â– 19,200 baud
â– No flow control
â– Critical log events
you would use the following command sequence:
ProCurve(config)# console terminal vt100 baud-rate 19200 flow-control none
events critical
Command will take effect after saving configuration and reboot
ProCurve(config)# write memory
ProCurve(config)# reload
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
write memory and reload.
Figure 7-4. Example of Executing the Console Command with Multiple Parameters
7-8
To Next Page
Loading...
Need help?
General
