EasyManua.ls Logo

HP PROCURVE 2520

HP PROCURVE 2520
544 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-------- ---------------------------------------------- ----------------
Time Protocols
SNTP: Viewing, Selecting, and Configuring
.
ProCurve(config)# show sntp
In this example, the Poll Interval and the Protocol
SNTP Configuration
Version appear at their default settings.
Time Sync Mode: Sntp
Both IPv4 and IPv6 addresses are displayed.
SNTP Mode : Unicast
Note: Protocol Version appears only when there is an
Poll Interval (sec) [720] : 720
IP address configured for an SNTP server.
Priority SNTP Server Address Protocol Version
-------- ---------------------------------------------- ----------------
1 2001:db8::215:60ff:fe79:8980 7
2 10.28.227.141 3
3 fe80::123%vlan10 3
Figure 9-8. Example of Configuring SNTP for Unicast Operation
If the SNTP server you specify uses SNTP version 4 or later, use the sntp server
command to specify the correct version number. For example, suppose you
learned that SNTP version 4 was in use on a server you specified above (IP
address 10.28.227.141) with version 3. You would use the following commands
to delete the server IP address and then re-enter it with the correct version
number for that server:
ProCurve(config)# no sntp server priority 2 10.28.227.141
ProCurve(config)# sntp server priority 2 10.28.227.141 4
5406_1(config)# show sntp
SNTP Configuration
Time Sync Mode: Sntp
SNTP Mode : Unicast
show sntp displays the
Deletes unicast SNTP
server entry.
Re-enters the unicast
server with a non-default
protocol version.
Poll Interval (sec) [720] : 720
changed server protocol
version.
Priority SNTP Server Address Protocol Version
1 2001:db8::215:60ff:fe79:8980 7
2 10.28.227.141 4
3 fe80::123%vlan10 3
Figure 9-9. Example of Specifying the SNTP Protocol Version Number
9-13

Table of Contents

Other manuals for HP PROCURVE 2520

Related product manuals