Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
Parameter Column Displays Examples
port Port identifier A2
type Port type 100/1000T
status Port status up or down
speed Connection speed and duplex 1000FDX
mode Configured mode auto, auto-100, 100FDX
mdi MDI mode auto, MDIX
flow Flow control on or off
name Friendly port name
vlanid The vlan id this port belongs to, 4
or “tagged” if it belongs to more
tagged
than one vlan
enabled port is or is not enabled yes or no
intrusion
intrusion Intrusion alert status no
bcast Broadcast limit 0
ProCurve(config)# show int custom 1-4 port name:4 type vlan intrusion speed
enabled mdi
Status and Counters - Custom Port Status
Intrusion
Port Name Type VLAN Alert Speed Enabled MDI-mode
---- ---------- ---------- ----- --------- ------- ------- --------
1 Acco 10/100T 1 No 100FDx Yes Auto
2 Huma 10/100T 1 No 100FDx Yes Auto
3 Deve 10/100T 1 No 100FDx Yes Auto
4 Lab1 10/100T 1 No 100FDx Yes Auto
Figure 10-6. Example of the Custom show interfaces Command
You can specify the column width by entering a colon after the column name,
then indicating the number of characters to display. In Figure 10-6 the Name
column only displays the first four characters of the name. All remaining
characters are truncated.
10-12
To Next Page
Loading...
Need help?
General
