Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
■ Display real-time status information about all installed transceivers,
including non-operational transceivers.
Figure 10-8 shows sample output from the show tech transceivers command.
ProCurve# show tech transceivers
Transceiver Technical Information:
Port # | Type | Prod # | Serial # | Part #
-------+-----------+--------+------------------+----------
9 | 1000SX | J4858B | CN605MP23K |
10 | 1000LX | J4859C | H117E7X | 2157-2345
Figure 10-8. Example of Show Tech Transceivers Command
Operating Notes:
■ The following information is displayed for each installed transceiver:
• Port number on which transceiver is installed.
• Type of transceiver.
• Product number—Includes revision letter, such as A, B, or C. If no
revision letter follows a product number, this means that no revision
is available for the transceiver.
• Part number—Allows you to determine the manufacturer for a spec-
ified transceiver and revision number.
■ For a non-ProCurve installed transceiver (see line 23 Figure 10-8), no
transceiver type, product number, or part information is displayed. In the
Serial Number field, non-operational is displayed instead of a serial num-
ber.
■ The following error messages may be displayed for a non-operational
transceiver:
• Unsupported Transceiver. (SelfTest Err#060)
Check: www.hp.com/rnd/device_help/2_inform for
more info.
• This switch only supports revision B and above
transceivers. Check: www.hp.com/rnd/device_help/
2_inform for more info.
• Self test failure.
• Transceiver type not supported in this port.
10-15
To Next Page
Loading...
