Power Over Ethernet (PoE) Operation
Viewing PoE Configuration and Status
For example, show power-over-ethernet brief displays this output:
ProCurve(config)# show power-over-ethernet brief
Status and Counters - Port Power Status
PoE | Power LLDP Power Alloc PoE Configured Detection Power
Port | Enable Detect Priority By Val Type Status Class
----- + ------- -------- --------- ----- ---- ----------- ----------- ------
1 | Yes disabled critical usage 17 W Telephone Delivering 1
2 | Yes disabled critical usage 17 W Telephone Delivering 1
3 | Yes disabled high usage 17 W Wireless Delivering 3
4 | Yes disabled high usage 17 W Wireless Delivering 3
5 | Yes disabled low usage 17 W Searching 0
6 | Yes disabled low usage 17 W Searching 0
7 | Yes disabled low usage 17 W Searching 0
8 | Yes disabled low usage 17 W Searching 0
Figure 11-5. Example of show power-over-ethernet brief Output
11-18
To Next Page
Loading...
