Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
In the following example, the show snmp-server command output shows that
the switch has been configured to send SNMP traps and notifications to
management stations that belong to the “public”, “red-team”, and “blue-team”
communities.
ProCurve(config)# show snmp-server
SNMP Communities
Community Name MIB View Write Access
---------------- -------- ------------
public Operator Restricted
blue-team Manager Unrestricted
red-team Manager Unrestricted
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Trap Category
------------------------------
SNMP Authentication
Password change
Login failures
Port-Security
Authorization Server Contact
Current Trap Configuration
extended
enabled
enabled
enabled
enabled
--------------------------
Address
---------------
10.28.227.200
10.28.227.105
10.28.227.120
Community
public
red-team
blue-team
----------
Events Sent
-----------
All
Critical
Not-INFO
Notify Type Retry
trap 3
trap 3
trap 3
----------- -----
Timeout
-------
15
15
15
...
SNMP Community
configuration
Link-change
trap setting
Figure 13-13. Display of SNMP Notification Configuration
13-32
To Next Page
Loading...
