File Transfers
Downloading Switch Software
Downloading from Primary Only.
Syntax:
copy tftp flash < ip-addr > flash [ primary | secondary ]
This command (executed in the destination switch)
downloads the software flash in the source switch’s primary
flash to either the primary or secondary flash in the
destination switch.
If you do not specify either a primary or secondary flash location for the
destination, the download automatically goes to primary flash.
For example, to download a software file from primary flash in a switch with
an IP address of 10.29.227.103 to the primary flash in the destination switch,
you would execute the following command in the destination switch’s CLI:
Running Total
of Bytes
Downloaded
Figure A-7. Switch-To-Switch, from Primary in Source to Either Flash in Destination
Downloading from Either Flash in the Source Switch to Either Flash
in the Destination Switch.
Syntax:
copy tftp flash < ip-addr > < /os/primary > | < /os/secondary > [ primary |
secondary ]
This command (executed in the destination switch) gives you
the most options for downloading between switches. If you do
not specify either a primary or secondary flash location for
the destination, the download automatically goes to primary
flash.
For example, to download a software file from secondary flash in a switch
with an IP address of 10.28.227.103 to the secondary flash in a destination
switch, you would execute the following command in the destination switch’s
CLI:
A-21
To Next Page
Loading...
Need help?
General