Switch Memory and Configuration
Multiple Configuration Files
With the same memory configuration as is shown in the bottom portion of
figure 6-22, executing erase startup-config boots the switch from primary flash,
resulting in a new file named minconfig in the same memory slot. The new file
contains the default configuration for the software version currently in pri-
mary flash.
Using the Clear + Reset Button Combination To Reset the
Switch to Its Default Configuration
The Clear + Reset button combination described in the Installation and
Getting Started Guide produces these results. That is, when you press the
Clear + Reset button combination, the switch:
• Overwrites the content of the startup-config file currently in memory
slot 1 with the default configuration for the software version in
primary flash, and renames this file to config1.
• Erases any other startup-config files currently in memory.
• Configures the new file in memory slot 1 as the default for both
primary and secondary flash locations (regardless of the software
version currently in secondary flash).
• Boots the switch from primary flash using the new startup-config file.
ProCurve# sho config files
Pressing Clear + Reset:
Configuration files:
– Replaces all startup-config files with a single
file named config that contains the default
configuration for the software version in
primary flash.
id | act pri sec | name
---+-------------+-----------------------------------------
– Resets the Active, Primary, and Secondary
1 | * * * | config
assignments as shown here.
2 | |
3 | |
Figure 6-23. Example of Clear + Reset Result
Transferring Startup-Config Files To or From a Remote
Server
Command Page
copy config < src-file > tftp < ip-addr > < remote-file > < pc | unix > [oobm] below
copy tftp config < dest-file > < ip-addr > < remote-file > < pc | unix > [oobm] below
6-37
To Next Page
Loading...
Need help?
General