EasyManuals Logo

HP ProCurve 6120G/XG Configuration Guide

HP ProCurve 6120G/XG
662 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #451 background imageLoading...
Page #451 background image
File Transfers
Downloading Switch Software
Enables/Disables TFTP.
Note: If SFTP is enabled, this field will be set to No. You
cannot use this field to enable TFTP if SFTP is enabled.
Attempting to do so produces an Inconsistent value
message in the banner below the Actions line.
Figure A-6. Using the Menu Interface To Disable TFTP
â–  While SFTP is enabled, TFTP and auto-TFTP cannot be enabled from the
CLI. Attempting to enable either non-secure TFTP option while SFTP is
enabled produces one of the following messages in the CLI:
SFTP must be disabled before enabling tftp.
SFTP must be disabled before enabling auto-tftp.
Similarly, while SFTP is enabled, TFTP cannot be enabled using an SNMP
management application. Attempting to do so generates an “inconsistent
value” message. (An SNMP management application cannot be used to
enable or disable auto-TFTP.)
â–  To enable SFTP by using an SNMP management application, you must
first disable TFTP and, if configured, auto-TFTP on the switch. You can
use either an SNMP application or the CLI to disable TFTP, but must use
the CLI to disable auto-TFTP. The following two CLI commands disable
TFTP and auto-TFTP on the switch.
Command Options
If you need to enable SSH v2 (which is required for SFTP) enter this command:
ProCurve(config)# ip ssh version 2
A-15

Table of Contents

Other manuals for HP ProCurve 6120G/XG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 6120G/XG and is the answer not in the manual?

HP ProCurve 6120G/XG Specifications

General IconGeneral
BrandHP
ModelProCurve 6120G/XG
CategorySwitch
LanguageEnglish

Related product manuals