HP ProCurve 6120G/XG

Network Out-of-Band Management (OOBM)
Tasks
OOBM IPv4 address configuration
Configuring an IPv4 address for the OOBM interface is similar to VLAN IP
address configuration, but it is accomplished within the OOBM context.
Syntax:
From the OOBM context:
[no] ip address [dhcp-bootp | ip-address/mask-length]
From the general configuration context:
[no] oobm ip address [dhcp-bootp | ip-address/mask-length]
Configures an IPv4 address for the switch’s OOBM interface.
You can configure an IPv4 address even when global OOBM
is disabled; that address will become effective when OOBM is
enabled.
For example:
ProCurve (oobm)# ip address 10.1.1.17/24
OOBM IPv4 default gateway configuration
Configuring an IPv4 default gateway for the OOBM interface is similar to VLAN
default gateway configuration, but it is accomplished within the OOBM con-
text.
Syntax:
From the OOBM context:
[no] ip default-gateway ip-address
From the general configuration context:
[no] oobm ip default-gateway ip-address
Configures an IPv4 default gateway for the switch’s OOBM
interface.
For example:
ProCurve (oobm)# ip default-gateway 10.1.1.1
G-10