EasyManuals Logo

HP ProCurve 6120G/XG Configuration Guide

HP ProCurve 6120G/XG
662 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #552 background imageLoading...
Page #552 background image
Troubleshooting
Using the Event Log for Troubleshooting Switch Problems
Log Throttle Periods
The length of the log throttle period differs according to an event’s severity
level:
Severity Level Log Throttle Period
I (Information) 6000 Seconds
W (Warning) 600 Seconds
D (Debug) 60 Seconds
M (Major) 6 Seconds
Example of Log Throttling
For example, suppose that you configure VLAN 100 on the switch to support
PIM operation, but do not configure an IP address. If PIM attempted to use
VLAN 100, the switch would generate the first instance of the following Event
Log message and counter.
W 10/01/06 09:00:33 PIM:No IP address configured on VID 100 (1)
The counter indicates that this is the first instance
of this event since the switch last rebooted.
Figure C-7. Example of the First Instance of an Event Message and Counter
C-34

Table of Contents

Other manuals for HP ProCurve 6120G/XG

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProCurve 6120G/XG and is the answer not in the manual?

HP ProCurve 6120G/XG Specifications

General IconGeneral
BrandHP
ModelProCurve 6120G/XG
CategorySwitch
LanguageEnglish

Related product manuals