Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Displaying the TLVs Advertised
The show commands display the configuration of the TLVs. The command
show lldp config lists the TLVs advertised for each port.
ProCurve(config)# show lldp config a1
LLDP Port Configuration Detail
Port : a1
A
dminStatus [Tx_Rx] : Tx_Rx
NotificationEnabled [False] : False
Med Topology Trap Enabled [False] : False
TLVS Advertised:
* port_descr
* system_name
* system_descr
* system_cap
* capabilities
* network_policy
* location_id
* poe
* macphy_config
* port_vlan_id
The VLAN ID TLV is being advertised.
IpAddress Advertised:
:
:
Figure 13-20. Displaying the TLVs for a Port
13-60
To Next Page
Loading...
Need help?
General