To Next Page

To Previous Page

Using the Command Line Interface (CLI)

Using the CLI

As mentioned above, if you type part of a command word and press [Tab], the

CLI completes the current word (if you have typed enough of the word for the

CLI to distinguish it from other possibilities), including hyphenated exten-

sions. For example:

ProCurve(config)# port-

[Tab]

ProCurve(config)# port-security _

Pressing

[Tab] after a completed command word lists the further options for

that command.

ProCurve(config)# qos

[Tab]

udp-portSet UDP port based priority.

tcp-portSet TCP port based priority.

device-priorityConfigure device-based priority.

dscp-mapDefine mapping between a DSCP

(Differentiated-Services Codepoint)

value and 802.1p priority.

type-of-serviceConfigure the Type-of-Service

method the device uses to

prioritize IP traffic.

Listing Command Options

You can use the CLI to remind you of the options available for a command by

entering command keywords followed by

?. For example, suppose you want

to see the command options for configuring the console settings:

This example displays the command options

for configuring the switch’s console settings.

Figure 4-5. Example of How To List the Options for a Specific Command

4-10

HP ProCurve 6120G/XG Configuration Guide

Other manuals for HP ProCurve 6120G/XG