Network Out-of-Band Management (OOBM)
Tasks
Show OOBM IP configuration
Use show oobm ip to see the IP configuration of the OOBM interface.
Syntax: show oobm ip
Summarizes the IP configuration of the OOBM interface. This
command displays the status of IPv4 (enabled/disabled), the
IPv4 default gateway, and the IPv4 address configured for the
interface.
You can issue this command from any context.
For example:
ProCurve# show oobm ip
Show OOBM ARP information
Use show oobm arp to see the ARP table entries for the OOBM interface.
Syntax: show oobm arp
Summarizes the ARP table entries for the OOBM interface.
You can issue this command from any context.
ProCurve# show oobm arp
G-12
To Next Page
Loading...
Need help?
General