Troubleshooting
Diagnostic Tools
source <ip-addr | oobm | vlan-id >
Source IP address, VLAN ID, or oobm. The source IP address
must be owned by the router. If a VLAN is specified, the IP
address associated with the specified VLAN is used. For
switches that have a separate out-of-band management
(OOBM) port, oobm specifies that the traffic originates from
the out-of-band management port.
data-size <0-65471>
Size of packet sent. Default: 0 (zero)
data-fill <0-1024>
The data pattern in the packet. Default: Zero length string
Figure C-12. Examples of Ping Tests
To halt a ping test before it concludes, press
[Ctrl] [C].
Note To use the ping (or traceroute) command with host names or fully qualified
domain names, refer to “DNS Resolver” on page C-78.
Link Tests
You can issue single or multiple link tests with varying repetitions and timeout
periods. The defaults are:
â– Repetitions: 1 (1 - 999)
â– Timeout: 5 seconds (1 - 256 seconds)
C-59
To Next Page
Loading...
Need help?
General