Switch Memory and Configuration
Multiple Configuration Files
Xmodem: Copying a Configuration File to a Serially
Connected Host
Syntax: copy config < filename > xmodem < pc | unix > [oobm]
This is an addition to the copy < config > xmodem command
options. Use this command to upload a configuration file
from the switch to an Xmodem host.
The oobm parameter specifies that the copy operation will go
out from the out-of-band management interface. If this
parameter is not specified, the copy operation goes out from
the data interface. Refer to Appendix G, “Network Out-of-
Band Management” in this guide for more information on
out-of-band management.
For more on using Xmodem to copy a file to a serially
connected host, refer to “Xmodem: Copying a Configuration
File to a USB Serial Console Connected PC or UNIX Worksta-
tion” on page A-28.
Xmodem: Copying a Configuration from a Serially
Connected Host
Syntax: copy xmodem config < dest-file > < pc | unix > [oobm]
This is an addition to the copy xmodem command options. Use
this command to download a configuration file from an
Xmodem host to the switch.
The oobm parameter specifies that the copy operation will go
out from the out-of-band management interface. If this
parameter is not specified, the copy operation goes out from
the data interface. Refer to Appendix G, “Network Out-of-
Band Management” in this guide for more information on
out-of-band management.
For more on using Xmodem to copy a file from a serially
connected host, refer to “Xmodem: Copying a Configuration
File from a Serially Connected PC or UNIX Workstation” on
page A-29.
6-40
To Next Page
Loading...
