Figure 1-5. Button for Onboard Administrator Interface Online Help
Need Only a Quick Start?
IP Addressing
If you just want to give the switch an IP address so that it can communicate
on your network, or if you are not using VLANs, ProCurve recommends that
you use the Switch Setup screen to quickly configure IP addressing. To do so,
do one of the following:
â– Enter setup at the CLI Manager level prompt.
Procurve# setup
â– In the Main Menu of the Menu interface, select
8. Run Setup
For more on using the Switch Setup screen, see the Installation and Getting
Started Guide you received with the switch.
1-8
To Next Page
Loading...
Need help?
General