HP ProCurve 6120G/XG

Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
ProCurve(config)# show lldp info local-device a1
LLDP Local Port Information Detail
Port : A1
PortType : local
PortId : 1
PortDesc : A1
Port VLAN ID : 1
The information that LLDP used in its
advertisement.
Figure 13-21. Example of Local Device LLDP Information
ProCurve(config)# show lldp info remote-device a1
LLDP Remote Device Information Detail
Local Port : A1
ChassisType : mac-address
ChassisId : 00 16 35 22 ca 40
PortType : local
PortId : 1
SysName : esp-dback
System Descr : ProCurve Switch, revision Z.14.01, ROM ...
P
ortDescr : A1
System Capabilities Supported : bridge, router
S
ystem Capabilities Enabled : bridge, router
Port VLAN ID : 200
Remote Management Address
Type
: ipv4
Address : 192.168.1.1
Figure 13-22. Example of Remote Device LLDP Information
SNMP Support
The LLDP-EXT-DOT1-MIB has the corresponding MIB variables for the Port
VLAN ID TLV. The TLV advertisement can be enabled or disabled using the
MIB object lldpXdot1ConfigPortVlanTxEnable in the
lldpXdot1ConfigPortVlanTable.
13-61