HP ProCurve 6120G/XG Configuration Guide

Interface Access and System Information
Interface Access: Console/Serial Link, Web, and Inbound Telnet
Note If you change the Baud Rate or Flow Control settings for the switch, you
should make the corresponding changes in your console access device. Oth-
erwise, you may lose connectivity between the switch and your terminal
emulator due to differences between the terminal and switch settings for these
two parameters.
All console parameter changes except events and inactivity-timer require that
you save the configuration with write memory and then execute boot before the
new console configuration will take effect.
For example, to use one command to configure the switch with the following:
■ VT100 operation
■ 19,200 baud
■ No flow control
■ 10-minute inactivity time
■ Critical log events
you would use the following command sequence:
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
write memory and reload.
Figure 7-4. Example of Executing the Console Command with Multiple Parameters
7-10

HP ProCurve 6120G/XG Specifications

General

Brand	HP
Model	ProCurve 6120G/XG
Category	Switch
Language	English