HP ProCurve 6120G/XG

Configuring IP Addressing
Configuring a Single Source IP Address
ProCurve(config)# ip source-interface radius address 10.10.10.2
ProCurve(config)# show ip source-interface radius
Source-IP Configuration Information
Protocol | Admin Selection Policy IP Interface IP Address
-------- + ----------------------- -------------- --------------
-
Radius | Configured IP Address vlan 3 10.10.10.2
Figure 8-11. Example of a Specific IP Address Assigned for the RADIUS Application Protocol
In figure 8-12, a VLAN interface (VLAN 22) is specified as the source IP address
for TACACS. The administrative policy is Configured IP Interface.
ProCurve(config)# ip source-interface tacacs vlan 22
ProCurve(config)# show ip source-interface tacacs
Source-IP Configuration Information
Protocol | Admin Selection Policy IP Interface IP Address
-------- + ----------------------- -------------- --------------
-
Tacacs | Configured IP Interface vlan 22 10.10.10.4
Figure 8-12. Example of Using a VLAN Interface as the Source IP Address for TACACS
Figure 8-13 shows a VLAN interface being specified as the source IP address
for logging. The administrative policy is Configured IP Interface.
ProCurve(config)# ip source-interface syslog vlan 10
ProCurve(config)# show ip source-interface syslog
Source-IP Configuration Information
Protocol | Admin Selection Policy IP Interface IP Address
-------- + ----------------------- -------------- ---------------
Syslog | Configured IP Interface vlan 10 10.10.10.10
Figure 8-13. Example of Using a VLAN Interface as the Source IP Address for Logging (Syslog)
8-23