Time Protocols
TimeP: Viewing, Selecting, and Configuring
ProCurve (config)# show timep
Timep Configuration
Time Sync Mode: Timep
TimeP Mode [Disabled] : Manual
Server Address : 10.10.28.100
Poll Interval (min) [720] : 720
OOBM : Yes
Figure 9-21. Example of TimeP Configuration When TimeP Is the Selected Time
Synchronization Method
If SNTP is the selected time synchronization method,
show timep still lists the
TimeP configuration even though it is not currently in use:
ProCurve (config)# show timep
Timep Configuration
Time Sync Mode: Sntp
TimeP Mode [Disabled] : Manual
Even though, in this example, SNTP is the
current time synchronization method, the
switch maintains the TimeP
configuration.
Server Address : 10.10.28.100
Poll Interval (min) [720] : 720
OOBM : Yes
Figure 9-22. Example of TimeP Configuration When TimeP Is Not the Selected
Time Synchronization Method
Syntax: show management
This command can help you to easily examine and compare
the IP addressing on the switch. It lists the IP addresses for
all time servers configured on the switch, plus the IP addresses
and default gateway for all VLANs configured on the switch.
9-31
To Next Page
Loading...
Need help?
General