Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
ProCurve(config)# show interfaces brief
Status and Counters - Port Status
| Intrusion MDI Flow Bcast
Port Type | Alert Enabled Status Mode Mode Ctrl Limit
----- --------- + --------- ------- ------ ---------- ----- ----- -----
-
B1 100/1000T | No Yes Down Auto-10-100 Auto off 0
B2
100/1000T | No Yes Down 1000FDx Auto off 0
B3 100/1000T | No Yes Down 1000FDx Auto off 0
B4 100/1000T | No Yes Down 1000FDx Auto off 0
B5 100/1000T | No Yes Down 1000FDx Auto off 0
B6 100/1000T | No Yes Down 1000FDx Auto off 0
Figure 10-3. Example of Show Interfaces Brief Command Listing
Use the show interfaces config command to view the port settings, as shown
below.
ProCurve(config)# show interfaces config
Port Settings
Port Type | Enabled Mode Flow Ctrl MDI
--
--- --------- + ------- ------------ --------- ----
B1 100/1000T | Yes Auto-10-100 Disable Auto
B2
100/1000T | Yes Auto Disable Auto
B3 100/1000T | Yes Auto Disable Auto
B4 100/1000T | Yes Auto Disable Auto
B5 100/1000T | Yes Auto Disable Auto
B6 100/1000T | Yes Auto Disable Auto
Figure 10-4. Example of a Show Interfaces Config Command Listing
The display option can be used to initiate the dynamic update of the show
interfaces command with the output being the same as the show interfaces
command. When using the display option in the CLI, the information stays on
the screen and is updated every 3 seconds, as occurs with the display using
the menu feature. The update is terminated with Cntl-C.
You can use the arrow keys to scroll through the screen when the output does
not fit in one screen.
10-9
To Next Page
Loading...
Need help?
General