To Next Page

To Previous Page

9. Install the chassis cover on page 29.

10. Connect all peripheral cables to the server.

11. Connect the power cord to the server power jack, and then to the AC source.

12. Power up the server on page 30.

Marvell Storage Utility

The Marvell Storage Utility (MSU) is a configuration and management utility for the embedded Marvell

88SE9230 PCIe to SATA 6Gb/s Controller. This Marvell storage controller supports hardware RAID 0, 1,

and 10 levels. Use the MSU to create and manage RAID virtual disks and arrays using the drives

connected to the embedded storage controller.

To enable MSU access through GUI or CLI, install the MSU in the server.

For more information, see the Marvell Storage Utility User Guide for HPE MicroServer Gen10 in the

Hewlett Packard Enterprise Support Center website:

http://www.hpe.com/info/microservergen10-docs

Installing the Marvell Storage Utility

Procedure

1. Go to the HPE ProLiant MicroServer Gen10 download page:

http://www.hpe.com/downloads/microservergen10

2. Click drivers, software & firmware.

3. Select the server OS from the operating system drop-down menu.

4. Click Utility.

5. Download the Marvell Storage Utility (MSU) for HPE MicroServer Gen10 Server

package to the target server.

6. Unzip the package and open the Marvell_MSU folder.

7. Follow the installation procedure described in the instructions.txt file.

Marvell BIOS Utility

The Marvell BIOS Utility (MBU) is built into the ROM of the embedded Marvell 88SE9230 PCIe to SATA

6Gb/s Controller. This Marvell storage controller supports the hardware RAID 0, 1, and 10 levels. Use the

MBU to create and manage RAID virtual disks and arrays using the drives connected to the embedded

storage controller.

For more information, see the Marvell BIOS Utility User Guide for HPE MicroServer Gen10 in the Hewlett

Packard Enterprise Support Center website:

http://www.hpe.com/info/microservergen10-docs

Accessing the Marvell BIOS Utility under UEFI boot mode

The UEFI boot mode is the server default boot mode.

76 Marvell Storage Utility

Other manuals for HPE ProLiant MicroServer Gen10

Questions and Answers:

Need help?

Do you have a question about the HPE ProLiant MicroServer Gen10 and is the answer not in the manual?

General

Product Line	HPE ProLiant
Server Type	MicroServer
Maximum Memory	32 GB
Memory Slots	2
Expansion Slots	1 PCIe 3.0 x8 slot
Form Factor	Ultra Micro Tower
Processor	AMD Opteron X3000 series
Memory Type	DDR4 ECC UDIMM
Storage	4 LFF non-hot plug drive bays
Network	2 x 1GbE ports
Power Supply	200W Non-Hot-Plug, Non-Redundant Power Supply
Dimensions	23.5 x 23 x 25.4 cm
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server
Management	HPE iLO Standard
RAID Support	HPE Smart Array S100i SR Gen10 (RAID 0, 1, 10)