Huawei BTS3902E WCDMA - 3.3 BTS3902 E Installation Options

Indicator Color Status Description
VSWR Red Off No VSWR alarm is generated.
Blinking red (on
for 1s and off for
1s)
VSWR alarms are generated on the
ANTB_TX/RX port.
Steady red VSWR alarms are generated on the
ANTA_TX/RX port.
Blinking red (on
for 0.125s and off
for 0.125s)
VSWR alarms are generated on the
ANTA_TX/RX and ANTB_TX/RX ports.
O/E Green Steady on The OPT1 or ETH port is connected
properly.
Blinking (on for
0.125s and off for
0.125s)
The OPT1 or ETH port is transmitting or
receiving data.
Off The OPT1 or ETH port is connected
improperly.
O Green Steady on The OPT0 port is connected properly.
Blinking (on for
0.125s and off for
0.125s)
The OPT0 port is transmitting or receiving
data.
Off The OPT0 port is connected improperly.
3.4 BTS3902E Installation Options
This section describes the BTS3902E installation options. A BTS3902E can be installed on a
pole, wall, or wood pole.
Installing a BTS3902E on a Pole with the Diameter of 60 mm to 114 mm (2.36 in. to
4.49 in.)
Figure 3-5 shows the diameter of a pole for installing a BTS3902E.
CAUTION
l The recommended diameter is 80 mm (3.15 in.).
3 Information About the Installation
BTS3902E WCDMA
Installation Guide
3-6 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue Draft A (2011-06-30)