Day/Night Switch OFF
Step 1 Draw the detection area as in the normal configuration mode. Up to 8 areas are supported.
Step 2 Select OFF for Switch Day and Night Settings.
Step 3 Select the area by clicking the area No.
Step 4 Slide the cursor to adjust the sensitivity and proportion of object on the area for the selected area.
Step 5 Set the arming schedule and linkage method as in the normal configuration mode.
Step 6 Click
to save the settings.
----End
Day/Night Auto-Switch
Step 1 Draw the detection area as in the normal configuration mode. Up to 8 areas are supported.
Step 2 Select Auto-Switch for Switch Day and Night Settings.
Figure 8-34 Day/Night Auto-switch
Step 3 Select the area by clicking the area No..
Step 4 Slide the cursor to adjust the sensitivity and proportion of object on the area for the selected area
in the daytime.
Step 5 Slide the cursor to adjust the sensitivity and proportion of object on the area for the selected area
at night.
Step 6 Set the arming schedule and linkage method as in the normal configuration mode.
Step 7 Click to save the settings.
----End
Day/Night Scheduled-Switch
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
8 Network Camera Configuration
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
98
To Next Page
Loading...
