NOTE
Use a plier to remove the removable part and route the cables via side outlet (as shown in Figure below)
if no cable hole is drilled in Step1, and connect the corresponding cables.
Figure 3-53 Remove the Removable Part
Step 6 View the image via the web browser.
Step 7 Slightly loosen the hex screw beside the WPS/RESET button to adjust the surveillance angle.
Step 8 Use the supplied adjusting tool to adjust the pan [±30°], tilt [0°~80°], and rotation direction [0°
~360°].
Figure 3-54 3-axis Adjustment
Step 9 Tighten the hex screw to fix the well-adjusted surveillance angle.
Step 10 Align the front cover to the dome drive and tighten the set screws on the front cover.
IPC6131-WD-A&6123-WDL-A&6232-IR&6212-
IR&6231-WD-VRZ&6332-MIR&6311-IR&6331-IR
User Guide
3 Camera Installation
Issue 02 (2014-12-25) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
37
To Next Page
Loading...
