Huawei NetCol5000-A - Page 257

NetCol5000-A 42 kW Air Cooled In-row Precision Air
Conditioner
User Manual
C Parameter Description
Issue 01 (2017-07-27)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
249
Menu
Parameter
Description
Default Value
Settings >
Comm
Settings > IP
Setting
IP assigning mode
Specifies the way of allocating IP addresses
for precision air conditioners.
Manual
IP address
Specifies the IP address for the precision air
conditioner.
192.168.000.010
Subnet mask
Specifies the subnet mask for the precision air
conditioner.
255.255.255.000
Gateway
Specifies the gateway for the precision air
conditioner.
192.168.000.001
Settings >
Comm
Settings > WiFi
Settings
WiFi SSID
Set WiFi SSID based on the actual
configuration; WiFi SSID is the name used
for the WiFi hotspot over which a mobile
phone can connect to the air conditioner.
NETCOL_6650b0
WiFi Password
Enter the WiFi password when you use a
mobile phone to connect to the WiFi. When
you enable the WiFi function for the first
time, you need to set a password.
N/A
Enable WiFi
Enable the WiFi function.
Disable
Settings >
Comm
Settings >
Modbus
Settings
Baud rate
The baud rate for the communication between
the precision air conditioner and the EMS can
be set to 9600 and 19200. The value should
be consistent with that set on the EMS.
9600
Comm address
Specifies the address for the communication
between the precision air conditioner and the
EMS.
1
Link mode

Server: The air conditioner, as a server,
supports two client connection and
establishes communication.

Client: The air conditioner, as a client, can
connect to a remote server and establish
communication.

Server and client: The air conditioner, as
a server, supports two client connection
and establishes communication. In
addition, the air conditioner, as a client,
can connect to a remote server and
establish communication.
Server and client
Client encrypt
This parameter is configurable when Link
mode is set to Client.
Enable
Server encrypt
This parameter is configurable when Link
mode is set to Server.
Disable
Network IP
Enter the actual IP address of the EMS. IP
addresses of the display panel, EMS client,
and EMS server must be unique. This
parameter is configurable when Link mode is
000.000.000.000