Huawei NetEngine 8000 F - Page 24

Table 3-4 Buttons on the NetEngine 8000 F1A-8H20Q
Silkscreen Name Description
RST Reset button You can press the RST
button to reset the NE or
restore the factory
settings of the NE.
The procedure is as
follows:
To reset the NE, press
the RST button and
release it.
From V8R13C00, to
restore factory settings,
press and hold the RST
button. This operation
will clear the NE
database and system
parameter
congurations
and cannot be restored.
Exercise caution when
you perform the
following operations:
1. Press and release the
RST button to restart the
NE.
2.When the STAT
indicator blinks as green
(the blinking frequency
is about 250 ms and the
time window is about 15
seconds), press and hold
the RST button.
3.Wait for no longer
than 2 minutes till the
STAT indicators blink as
orange(the time window
is 5 seconds). Then
release the RST button
immediately.
HUAWEI NetEngine 8000 F
Hardware Guide 3 Hardware Description
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 13