Huawei NetEngine 8000 F

5. Install the device into the cabinet. Facing the front of the cabinet, horizontally
slide the chassis into the cabinet until the mounting brackets are in close
contact with the mounting rails and aligned with the floating nuts. Secure the
mounting brackets to the cabinet with M6 screws.
Figure 4-262 Install the device into the cabinet
NO TE
Install the device in the cabinet when facing the front side of the cabinet.
CA UTION
Considering the weight of the device, it is recommended that at least two persons
move it to the cabinet to prevent it from falling and possibly causing injury.
4.2.6 Cable Routing Planning
Context
To ensure that power cables are connected in order, you are advised to plan power
cable routing.
NO TICE
Do not bundle or route outdoor cables (such as outdoor antenna feeders and
outdoor power cables) and indoor cables together in the cabinet or on the cable
tray.
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 610