Huawei NetEngine 8000 F User Manual

Table 4-58 PDF circuit breaker specications
Item Description Remarks
Circuit breaker of
each channel
≥ 50 A
NOTICE
The circuit breaker
current must not
be greater than
the maximum
derating current of
the device.
-
Installing Power Cables
1. Connect the power cord to the power connector.
2. Attach temporary labels to both ends of each power cable.
3. Route power cables along the cable ladder and lay them on the chassis.
4. Take
o the plastic cover from each power module, connect one end of each
power cable to the corresponding terminal (it is recommended that the power
cable is connected only to power jack A on the right of the power module)
and the other end to the PDF.
Figure 4-255 Installing the DC Power Cables
HUAWEI NetEngine 8000 F
Hardware Guide 4 Hardware Installation and Parts Replacement
Issue 05 (2023-03-31) Copyright © Huawei Technologies Co., Ltd. 603

Huawei NetEngine 8000 F Specifications

General

Brand	Huawei
Model	NetEngine 8000 F
Category	Network Router
Language	English