124 7. Calibration and Maintenance GSP9700 Series Road Force Measurement System Operation
Position the calibration tool on the spindle shaft using the spindle shaft slot closest to
the end of the tool. Place load roller at position “1.” Tap the foot pedal once or press
“Enter Cal Step.”
NOTE: If the load roller is unstable while entering any step, a long,
high-pitched tone will sound to advise you that the step has
NOT been entered. You must stabilize the load roller and re-
enter the step.
Position the calibration tool on the spindle shaft using the middle spindle shaft slot.
Place load roller at position “2.” Tap the foot pedal once or press “Enter Cal Step.”
To Next Page
Loading...
