52 4. Balancing a Wheel GSP9700 Series Road Force Measurement System Operation
Place the required amount of adhesive weight in the weight clip on the inner Dataset
®
arm and remove the peel-off backing from the adhesive weight.
NOTE: The adhesive weight strip should be centered in the weight
clip and the peel-off backing should face away from the inner
Dataset
®
arm.
Using dimensional information previously obtained, the on-screen graphic displays
and identifies the exact location of the weight plane and the current position of the
inner Dataset
®
arm. Pull the inner Dataset
®
arm out from the base until the arm and
the weight location are overlapping.
Maintaining that distance, rotate the Dataset
®
arm toward the inner rim surface, and
then apply the adhesive weights to the rim by pressing the adhesive weight release tab.
NOTE: If the servo is off (but is enabled in setup), pressing the
“START” button with the hood in the RAISED position will
restart the servo for adhesive weight application.
To Next Page
Loading...
