Husky Unify - Training; Nameplates; Hot Runner Nameplate

NOTE:
The NOTE alert is used to add information to a subject that does not t within the general ow of
the document.
IMPORTANT!
The IMPORTANT alert is used to highlight important steps, conditions, or considerations related to
the subject.
1.6 Training
All designated operators and maintenance personnel must be fully trained before using or
servicing Husky injection molding systems.
If training is required, visit www.husky.co or contact your nearest Husky Regional Service and
Sales oce to learn more about Husky’s training solutions.
IMPORTANT!
It is the obligation of the employer to properly train and instruct all personnel in the safe methods
of operation and maintenance. Manuals and other reference material, which have been prepared
by Husky for the operation and maintenance of Husky equipment, do not in any way absolve the
employer from fullling these obligations and Husky disclaims liability for injury to personnel
which is attributable to the employer's failure to do so.
1.7 Nameplates
Nameplates are axed to the operator’s side of the mold and hot runner for quick identication
of the equipment type, source and general specications.
IMPORTANT!
The mold and hot runner nameplates must never be removed. The information on the
nameplates is necessary for mold selection, setup, parts ordering and troubleshooting.
Immediately order a new nameplate for the mold or hot runner if it is missing or damaged.
1.7.1 Hot Runner Nameplate
Every hot runner nameplate lists the following information:
v 2.2 — March 2021 Unify Manifold System
12 Training