2.3.6 Slip, Trip or Fall Hazards
Do not walk, stand, climb or sit on machine surfaces not approved for safe access.
Do not step on the tie bar or any surfaces with grease and/or oil.
Use a safety approved platform, walkway and step ladders designated to access areas that are not
accessible from the oor.
2.3.7 Lifting Hazards
When lifting equipment, use suitable lifting devices, proper balancing techniques and designated
lifting points. Refer to the installation details, and to handling and lifting instructions. Do not
exceed the rated capacity of the lifting equipment.
2.4 Safety Signs
Safety signs clearly mark potentially hazardous areas in or around equipment. For the safety of
personnel involved in equipment installation, operation and maintenance, use the following
guidelines:
• Verify that all signs are in the proper locations. Refer to the drawing package for details.
• Do not alter signs.
• Keep signs clean and visible.
• Order replacement signs when necessary. Refer to the drawing package for part numbers.
The following safety symbols may appear on safety signs:
NOTE:
Safety signs may include a detailed explanation of the potential hazard and associated
consequences.
Safety Symbol
(ANSI)
Safety Symbol
(ISO)
General Description of Symbol
General
This symbol indicates a potential personal injury hazard. It is
usually accompanied by another pictogram or text to
describe the hazard.
Hazardous Voltage
This symbol indicates a potential electrical hazard that will
cause death or serious injury.
Hot Runner Installation Manual v 2.2 — March 2021 Safety Summary
Safety Hazards 21
To Next Page
Loading...
