7.2.1 Storing in the Machine
1. Open the clamp to full shutheight.
2. Lock out and tag the machine and controller (if equipped). Refer to Section 2.5 for more
information.
3. Clean the mold, hot runner and molding surfaces of dirt, debris and condensation.
4. Perform all required preventive maintenance procedures. Refer to Section 6.1 for more
information.
5. Inspect all moving components for damage. Replace or repair as needed.
WARNING!
Poison hazard – risk of death or serious injury. Protective sprays can cause headaches,
dizziness, nausea and anesthetic eects. Wear a face shield and solvent resistant gloves. If
used in an enclosed area, use an organic vapor respirator or self-contained breathing
apparatus.
6. Spray all accessible faces and molding surfaces with a protective spray. Allow surfaces to dry
for approximately two hours. Refer to Section 3.9 for information about recommended
lubricants.
If additional coats are required, make sure the hot runner has thoroughly dried before the
next application.
7. Leave the mold open.
7.2.2
Storing Outside the Machine
To store the hot runner separately from the machine for a period of less than three months, do
the following:
1. Open the clamp to full shutheight.
2. Lock out and tag the machine and controller (if equipped). Refer to Section 2.5 for more
information.
3. Purge all cooling water from the hot runner. Refer to the machine manufacturer’s
documentation for more information.
4. Clean the mold, hot runner and molding surfaces of dirt, debris and condensation.
5. Perform all required preventive maintenance procedures as required. Refer to Section 6.1 for
more information.
6. Inspect all moving components for damage. Replace or repair as needed.
WARNING!
Poison hazard – risk of death or serious injury. Protective sprays can cause headaches,
dizziness, nausea and anesthetic eects. Wear a face shield and solvent resistant gloves. If
used in an enclosed area, use an organic vapor respirator or self-contained breathing
apparatus.
v 2.2 — March 2021 Unify Manifold System
122 Storing in the Machine
To Next Page
Loading...
