Husky Unify - Changing the Resin Color

12. Measure the nozzle tip height from the manifold (Dimension T) to verify it matches the
assembly drawing. Refer to Figure 6-4.
2
1
3
Figure 6-4: Measure Preloaded Retainer Height and Nozzle Tip Height from Manifold
1. Manifold 2. Dimension S 3. Dimension T
6.3
Changing the Resin Color
To change the color of the resin, do the following:
v 2.2 — March 2021 Unify Manifold System
66 Changing the Resin Color