Issue: v 2.2 — March 2021
Document No.: 7593574
This product manual is intended to provide information for safe operation and/or maintenance.
Husky reserves the right to make changes to products in an eort to continually improve the
product features and/or performance. These changes may result in dierent and/or additional
safety measures that are communicated to customers through bulletins as changes occur.
This document contains information which is the exclusive property of Husky Injection Molding
Systems Limited. Except for any rights expressly granted by contract, no further publication or
commercial use may be made of this document, in whole or in part, without the prior written
permission of Husky Injection Molding Systems Limited.
Notwithstanding the foregoing, Husky Injection Molding Systems Limited grants permission to its
customers to reproduce this document for limited internal use only.
Husky
®
product or service names or logos referenced in these materials are trademarks of Husky
Injection Molding Systems Ltd. and may be used by certain of its aliated companies under
license.
All third-party trademarks are the property of the respective third-party and may be protected by
applicable copyright, trademark or other intellectual property laws and treaties. Each such third-
party expressly reserves all rights into such intellectual property.
©
2016 – 2021 Husky Injection Molding Systems Ltd. All rights reserved.
v 2.2 — March 2021 Unify Manifold System
ii
To Next Page
Loading...
