Husky Unify - Page 8

6.15.1.2 Disassembling the Hot Runner for Fluidized Bed Cleaning.........................................106
6.15.1.3 Removing the PEEK Bushings.................................................................................................108
6.16 Removing Insulating Gate Bubbles (If Equipped)............................................................................................ 108
6.17 Removing and Installing the Sprue Heater (If Equipped)..............................................................................112
6.17.1 Removing a Sprue Heater with a Built-In Thermocouple............................................................. 112
6.17.2 Removing a Sprue Heater with a Separate Thermocouple.......................................................... 112
6.17.3 Installing a Sprue Heater with a Built-In Thermocouple................................................................113
6.17.4 Installing a Sprue Heater with a Separate Thermocouple............................................................ 114
6.18 Removing and Installing the Sprue Bushing......................................................................................................115
6.18.1 Removing the Sprue Bushing..................................................................................................................116
6.18.2 Installing the Sprue Bushing....................................................................................................................116
6.19 Removing and Installing Nozzle Tip Insulators (If Equipped).......................................................................118
6.19.1 Removing the Nozzle Tip Insulators..................................................................................................... 118
6.19.2 Installing Nozzle Tip Insulators............................................................................................................... 119
Chapter 7: Storage and Shipping..................................................................................................................121
7.1 Corrosion Protection......................................................................................................................................................121
7.2 Short Term Storage........................................................................................................................................................ 121
7.2.1 Storing in the Machine.................................................................................................................................122
7.2.2 Storing Outside the Machine.....................................................................................................................122
7.3 Long Term Storage......................................................................................................................................................... 123
7.4 Shipping the Hot Runner............................................................................................................................................. 123
v 2.2 — March 2021 Unify Manifold System
viii