Husqvarna AUTOMOWER 310 Technical Manual

English - 34
2.7.6 Calibrate
You can use this function to calibrate the tilt sensor and
guide wire.
Calibrate tilt sensor
To calibrate, i.e. reset the tilt sensor: Place the robotic
lawnmower on a horizontal surface. Place the cursor
on Calibrate tilt sensor and press OK.
Calibrate Guides
Guide wires are calibrated automatically during the
starting sequence and after factory rest of the mower.
A manual calibration from this menu alternative may be
necessary in certain situations however. For example,
if a new guide wire is installed or the charging station
installation is changed, e.g. stretching the boundary wire
or guide wire.
To calibrate installed guide wires:
1. Place mower in charging station.
2. Enable Calibrate guides from the menu.
3. Press OK and start the mower.
4. Calibration is complete once the mower starts the
blade motor.
Calibrate tilt sensor
Calibrate guides
Info
History, total
History, trip
Test
Special settings
Calibrate
2. SPECIAL MENU FUNCTIONS
TH_1158203_310_315_GARDENA_US.indd 34 2016-05-11 10:16:07

Husqvarna AUTOMOWER 310 Specifications

General

Cutting Width	22 cm
Cutting Height Min	20 mm
Cutting Height Max	50 mm
Battery Type	Li-ion
Typical Charging Time	60 min
Typical Mowing Time per Charge	70 min
Maximum Incline Within the Working Area	40%
Working Area Capacity	1000 m²
Battery Capacity	2.1 Ah
Weight	9.4 kg
Battery Voltage	18 V
Operating Time	70 min
Maximum Area	1000 m²
Weather Resistance	Yes
Smart Connectivity	No
Blade Type	Pivoting razor blades