Print Language (TCP/IP IPDS)
PRINT LANGUAGE specifies the set of print languages used by the printer. Refer
to the previous page for print language menus.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A and OCR
B are the only available values for this parameter. If a different print quality value
is desired, the print language must be changed first.
Note:
This configuration value applies only to IPDS on the Ethernet. For Coax or
Twinax IPDS, use the corresponding configuration value in the Coax or
Twinax Interface menu.
Undefined Character Substitution (TCP/IP IPDS)
Undefined Character Substitution specifies the replacement character to print in
place of any unprintable character that is received by the host.
v X'60' (the default)
v X'40' - X'FE'
Note:
This configuration value applies only to IPDS on the Ethernet. For Coax or
Twinax IPDS, use the corresponding configuration value in the Coax or
Twinax Interface menu.
Maximum Printable Width (TCP/IP IPDS)
Maximum Printable Width sets the maximum width of the printer when using an
IPDS host interface.
v 13.2 Inches (the default)
v 13.6 Inches
Note:
This configuration value applies only to IPDS on the Ethernet. For Coax or
Twinax IPDS, use the corresponding configuration value in the Coax or
Twinax Interface menu.
148 Infoprint 6500 User’s Manual
To Next Page
Loading...
Need help?
General