Override Host (Emulation Configuration)
Override Host determines if the operator panel overrides specified IPDS menu
values.
Select one of the following two values:
v Disable (the default). Does not allow operator panel settings to override IPDS
application commands.
v Enable. Allows operator panel settings to override IPDS application commands.
The
specified IPDS application commands for the IPDS menu values are:
v Graphics Quality
v Bar Code Quality
v Image Quality
Note: No other IPDS menu values or printer operator panels are affected by
Override Host. Only the three values listed above are affected.
Graphics Quality
Determines the quality for graphics printing. Override Host must be enabled to
use these settings. Here are the supported resolutions in pels:
v Medium (the default). Vertical is 144; horizontal is 120.
v High. Vertical is 144; horizontal is 180.
v Low. Vertical is 72; horizontal is 60.
Note:
The higher the resolution selected, the slower the print speed. When
selecting a resolution, try to balance the resolution quality your application
requires with how fast you want the print job to print.
Bar Code Quality
Determines the quality for graphics printing. Override Host must be enabled to
use these settings. Below are the values for non-rotated bar codes.
v High (the default). Vertical is 144; horizontal is 120.
v Low. Vertical is 72; horizontal is 60.
Note:
The higher the resolution you select, the slower the print speed. When
selecting a resolution, try to balance the resolution quality your application
requires with how fast you want the print job to print.
Chapter 4. The Configuration Menus 149
To Next Page
Loading...
Need help?
General