Width Limit:
v Disable (the default). This does not limit the width of expanded characters.
v Enable. When enabled, limits the width of expanded characters based on a fixed
maximum ratio of width over height.
Absorb
at ^PN:
v Disable (the default). When disabled, system terminators following the (cc)PN
command are sent to the printer and result in paper motion.
v Enable. Prevents paper motion following the (cc)PN command.
IGP110
Compatibility:
v Enable (the default). This menu will process ^IPEXP commands in the same
manner the IGP does, and does not expand special font characters if an ^IPEXP
command precedes it.
v Disable. If disabled, it will allow the special font characters to be expanded.
Inline
Graphics:
v Disable (the default). Requires the printer move to the beginning of the line to
start a graphic.
v Enable. Permits Code V graphics to start in the middle of a print line as
opposed to moving to the beginning of the line to start a graphic.
LF
For Term:
v Disable (the default). The LF command ( ^, ) used to terminate a graphic
command sequence will not be performed as LF.
v Enable. The LF command ( ^, ) used to terminate a graphic command sequence
will be performed as LF.
Error Handling
Error Messages:
v Enable (the default). Checks command syntax and prints error messages when
command parameters are incorrect.
v Disable. Suppresses error checking and error messages.
Chapter 4. The Configuration Menus 173
To Next Page
Loading...
