EasyManua.ls Logo

IBM 6500 - Page 259

IBM 6500
334 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Table 10. Fault Messages (continued)
Fault Message
Operator
Correctable? Explanation Solution
LOADING PROGRAM INTO
FLASH
N/A The printer has deleted the
previous program from flash
memory and is loading the
new program into flash
memory.
No action required.
NOT READY N/A Printer state message: printer
is offline, not in
communication with host.
No action necessary.
ONLINE
CU TIMED OUT
No Controller unit timed out. Contact your IBM service
representative.
OPERATOR MENU
<first menu item>
N/A Non-error status message. No action necessary.
OPERATOR MENU LOCKED N/A Non-error status message. No action necessary.
OPERATOR MENU
UNLOCKED
N/A Non–error status message. No action necessary.
P00 ERROR:SYSTEM FAULT Yes Firmware error on the
controller board.
Cycle power. Run the print job
again. If the message appears,
download the emulation
software again. If the message
appears again, contact your
IBM service representative.
P05 DIAGNOSTIC TEST
PASSED
N/A Non–error status message. No action required.
P17 SECURITY VIOLATION No Security code of PAL on
controller board does not
match code of firmware on
the controller board.
Contact your IBM service
representative.
PA1 SELECTED N/A Attach status message. No action necessary.
PA2 SELECTED N/A Attach status message. No action necessary.
PAP FD DRVR CIR*
SEE USER’S MANUAL
No Paper Feed Driver Circuit.
The paper feed driver circuit
on the controller board is
drawing too much current.
Contact your IBM service
representative.
PRINTER UNDER REMOTE
CONTROL
Yes Indicates that remote
management software has
control of the printer.
No action necessary
QUEUE OVERRUN No In CT twinax emulation, the
print buffer has overflowed.
Contact your IBM service
representative.
READY N/A Printer state message: printer
is online and in
communication with host.
No action necessary.
RESETTING...PLEASE WAIT N/A Status message: the printer
finished loading the program
into flash memory and is
automatically resetting itself.
No action required.
RESTORING BOOT CODE N/A Normal download
initialization message.
No action required.
Chapter 6. Routine Service and Diagnostics 245

Table of Contents

Related product manuals