8. Remove the failed battery pack by sliding it out of the interconnect-battery unit.
Note: There are two battery packs in the interconnect-battery unit. The right
and left Battery Needs Attention LEDs on the interconnect-battery unit
correspond to each of the two battery packs. Be sure to remove the
failed battery, as indicated by the lit amber Battery Needs Attention
LED.
The battery pack is mounted to a sheet metal bracket. The sheet metal bracket
has a flange formed on the end of the bracket closest to the access in the
interconnect-battery unit. Grasp the flange to slide the battery pack from the
interconnect-battery unit.
CAUTION:
This product contains a sealed Lithium Ion battery. Discharged Lithium
and Lithium Ion batteries are currently designated to be disposed of in
normal trash. However, users should contact their municipal waste
disposal facility prior to discarding any used battery in normal trash.
Alternatively, IBM recommends users may return Lithium, Lithium Ion
and Lithium Ion battery packs to IBM for recycling.
In the United States, IBM has established a collection process for reuse,
recycling, or proper disposal of used IBM Lithium, Lithium Ion and
Lithium Ion battery packs. For information on proper disposal of these
batteries, please contact IBM at 1-800-426-4333. Please have the IBM part
number listed on the battery available prior to your call.
For information on disposal of sealed Lithium Ion batteries outside the
United States, go to http://www.ibm.com/ibm/environment/products/
batteryrecycle.shtml
or contact your local waste disposal facility.
9. Install the replacement battery pack. Carefully position the battery pack to
ensure that the battery pack will slide correctly into the interconnect-battery
unit. The flat side of the battery pack should face towards the outside of the
chassis. Make sure that the battery bracket slides properly into the slots for the
battery. Slide the battery pack into the interconnect-battery unit. Push the
battery pack firmly into the interconnect-battery unit to ensure that the battery
pack completely engages with the connectors in the interconnect-battery unit.
10. Reinstall the battery access cover onto the front of the interconnect-battery
unit.
11. Once you have replaced the battery pack, you must reset the battery age
through the DS4000 Storage Manager client, by performing these three steps:
v First, you must select the Controller enclosure components icon in the
Physical View of the Storage Manager client. The Controller enclosure
components dialog will be displayed.
v Next, you must select the Batteries icon, and then select Reset. You will be
asked to Confirm Reset. Select Yes to confirm that you want to reset the
battery age.
162 IBM System Storage DS4800 Storage Subsystem: Installation, User’s, and Maintenance Guide
To Next Page
Loading...
Need help?
General